Submarine Hull Structure Parts

(Page 13) End item NSN parts page 13 of 39
Part Number
NSN
NIIN
1090-41565 ITEM 40 Machine Thread Plug
014440506
10917099 Nonmetallic Bushing
004463269
109303 Tapered Roller Bearing Cup
001000501
10A16817 Ignition Coil
000384447
10AB-MOD Dishwashing Machine
011016261
10AB/NSU Dishwashing Machine
011016261
10ABMOD Dishwashing Machine
011016261
10AF10C805APC12-14 Bolt Assembly
003951056
10HA2C1L(YYRR)N3R1 Indicator Light
011283755
10M4156 Test Lead
001751431
11024189 Pipe Union
001892588
11024189-4 Pipe Union
001892588
11038B Cable Assembly
013217339
11040850-1 Tapered Roller Bearing
001005287
110443 Spring Resiliency Tester
004987910
110901PC9 O-ring
003383993
111.57960006-18 Machine Screw
014769781
111164 Wire Rope Hoist
009329751
1114247 Electromagnetic Relay
010268386
Page: 13 ...

Submarine Hull Structure

Picture of Submarine Hull Structure

A light hull (casing in British usage) of a submarine is the outer non-watertight hull which provides a hydrodynamically efficient shape. The pressure hull is the inner hull of a submarine; this holds the difference between outside and inside pressure.

Modern submarines are usually cigar-shaped. This design, already visible on very early submarines is called a "teardrop hull", and was patterned after the bodies of whales. It significantly reduces the hydrodynamic drag on the sub when submerged, but decreases the sea-keeping capabilities and increases the drag while surfaced.

The concept of an outer hydrodynamically streamlined light hull separated from the inner pressure hull was first introduced in the early pioneering submarine Ictineo I designed by the Catalan inventor Narcís Monturiol in 1859. However, when military submarines entered service in the early 1900s, the limitations of their propulsion systems forced them to operate on the surface most of the time; their hull designs were a compromise, with the outer hulls resembling a ship, allowing for good surface navigation, and a relatively streamlined superstructure to minimize drag under water. Because of the slow submerged speeds of these submarines, usually well below 10 knots (19 km/h), the increased drag for underwater travel by the conventional ship like outer hull was considered acceptable. Only late in World War II, when technology enhancements allowed faster and longer submerged operations and increased surveillance by enemy aircraft forced submarines to spend most of their times below the surface, did hull designs become teardrop shaped again, to reduce drag and noise. USS Albacore (AGSS-569) was a unique research submarine that pioneered the American version of the teardrop hull form (sometimes referred to as an "Albacore hull") of modern submarines. On modern military submarines the outer hull (and sometimes also the propeller) is covered with a thick layer of special sound-absorbing rubber, or anechoic plating, to make the submarine more difficult to detect by active and passive SONAR.

قارن الآن»
واضح | أخفى