رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
S1 spline tooth is omitted; splined end has threaded hole 90 degrees by 0.260 in diameter c'sk; threads per 0.250-28unf-3b 0.625 in thread depth; 1 end has hex nut with distances between opposite flats of between 0.740 in and 0.752 inch
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Splined (involute)
MRC:
A term used to identify the ends as identical or not identical.AAHN
End Similarity:
Not identical
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
9.253 inches
MRC:
The length of a straight line which passes through the center of the first end,and terminates at the circumference.AMDL
First End Diameter:
0.5152 inches
MRC:
A measurement of the longest dimension of the first end spline,in distinction from width.AMDM
First End Spline Length:
7.065 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the first end spline,and terminates at the circumference.AMDN
First End Spline Minor Diameter:
0.5150 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the first end spline,and terminates at the circumference.AMDP
First End Spline Major Diameter:
Between 0.6237 inches and 0.6242 inches
First End Pressure Angle:
30.0 degrees
MRC:
A measurement indicating the diameter-pitch per measurement scale of the first end.AMDS
First End Pitch Diameter:
0.5833 inches
First End Spline Quantity:
14
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
125.0 microinches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Stainless steel
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Ams 5643 cond h-1150 17-4ph assn standard single material response
