رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
One o-ring no. Bacp11p327 installed on groove 2.680 in. From 1st end, nylon smubber attached to largest flange
TXT
وصف:
Shouldered Shaft
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Splined (involute)
MRC:
A term used to identify the ends as identical or not identical.AAHN
End Similarity:
Not identical
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the second end.AAHP
Second End Style:
Splined (involute)
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
9.680 inches
MRC:
The length of a straight line which passes through the center of the first end,and terminates at the circumference.AMDL
First End Diameter:
2.0625 inches
MRC:
A measurement of the longest dimension of the first end spline,in distinction from width.AMDM
First End Spline Length:
1.350 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the first end spline,and terminates at the circumference.AMDN
First End Spline Minor Diameter:
Between 1.7650 inches and 1.8750 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the first end spline,and terminates at the circumference.AMDP
First End Spline Major Diameter:
Between 2.0575 inches and 2.0625 inches
First End Pressure Angle:
30.0000 degrees
MRC:
A measurement indicating the diameter-pitch per measurement scale of the first end.AMDS
First End Pitch Diameter:
2.0000 inches
MRC:
The length of a straight line which passes through the center of the second end,and terminates at the circumference.AMFZ
Second End Diameter:
1.6875 inches
MRC:
A measurement of the longest dimension of the second end spline,in distinction from width.AMGA
Second End Spline Length:
2.0000 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the second end spline,and terminates at the circumference.AMGB
Second End Spline Minor Diameter:
1.5000 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the second end spline,and terminates at the circumference.AMGC
Second End Spline Major Diameter:
1.6875 inches
Second End Pressure Angle:
30.0000 degrees
MRC:
A measurement indicating the diameter-pitch per measurement scale of the second end.AMGF
Second End Pitch Diameter:
1.6250 inches
MRC:
The number of steps provided.ATPC
Step Quantity:
7
First End Spline Quantity:
26
Second End Spline Quantity:
32
MRC:
The length of a straight line which passes through the center of the largest step,and terminates at the circumference.CSPY
Largest Step Diameter:
2.750 inches
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
63.0 microinches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Bms 7-6 boeing co, vertol div mfr ref single material response
