رقم الجزء
تجريد
صلاحيه
UOM
NIIN
MRC:
The ability of an item to withstand a specified torque load without fracture.AAPL
Torque Load Rating:
30.0 inch-pounds
MRC:
The length of a straight line which passes through the center of the smallest cross section of a spline,and terminates at the circumference.AAUH
Spline Minor Diameter:
Between 0.346 inches and 0.351 inches
MRC:
The length of a straight line which passes through the center of the largest cross section of a spline,and terminates at the circumference.AAUJ
Spline Major Diameter:
0.414 inches
MRC:
Indicates the type of mount utilized to support the item.AAXX
Mounting Type:
Flange
MRC:
The number of splines on or in the item.ABSA
Spline Quantity:
12
MRC:
The length of a straight line which passes through the center of a mounting hole,and terminates at the circumference.ABTB
Mounting Hole Diameter:
Between 0.276 inches and 0.291 inches
MRC:
The number of mounting holes provided.ABTJ
Mounting Hole Quantity:
4
MRC:
The speed of the drive shaft required to produce the rated capacity of an item,expressed in revolutions per minute.AEQC
Operating Speed At Rated Capacity In Rpm:
2500.0
MRC:
A measurement indicating the diameter-pitch per specific measurement scale of the item.AGJS
Pitch Diameter:
Between 0.049 inches and 0.051 inches
MRC:
Indicates the type of drive shaft by the physical configuration,condition,and the like of the shaft end.AJAB
Drive Shaft Type:
Splined, involute internal
MRC:
A measurement of the spline pitch of the item.ASAP
Spline Pitch:
32/64
MRC:
The maximum rated working pressure of an item at a specified temperature range.AXFB
Maximum Working Pressure Rating At Specificationified Tempurature Range:
3000psi at minus 54 degrees c to plus71 degrees c
MRC:
The pressure angle of the spline,expressed in degrees.AXFG
Spline Pressure Angle In Deg:
30.0
MRC:
A measurement of the longest dimension of a spline,in distinction from width.AXFH
Spline Length:
Between 0.627 inches and 0.677 inches
MRC:
Indicates the displacement type.AXFP
Displacement Type:
Constant or variable
MRC:
An indication of the constant displacement per revolution.AXFQ
Constant Displacement Per Revolution:
0.040 cubic inches
