رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
66 right and left hand groves equally spaced by generating with 7, 8, 9, on 10 partial diamonds when measured along groves from id and od of facing both sides
TXT
وصف:
Vehicular Clutch Disk
MRC:
The length of a straight line which passes through the center of the largest cross section of a spline,and terminates at the circumference.AAUJ
Spline Major Diameter:
7.622 inches
MRC:
A measurement of the smallest dimension of an item,in distinction from length or width.ABNM
Thickness:
Between 0.157 inches and 0.163 inches
MRC:
A measurement of the smallest dimension of the material,in distinction from length or width.ABPX
Material Thickness:
0.020 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
2350-01-087-1095
MRC:
The length of a straight line which passes through the center of the largest diameter of an item,and terminates at the outside circumference.AGWM
Largest Outside Diameter:
7.622 inches
MRC:
The angle between the lugs,expressed in degrees.AJAS
Angle Between Lugs In Deg:
20.000
MRC:
Indicates the design type of the item.APGF
Design Type:
Dry
MRC:
Indicates the location of the item to which a specific material is applicable.AQQF
Material Location:
Both sides
MRC:
The terminology used to indicate the arrangement of the teeth.AQQH
Tooth Arrangement:
Sets equally spaced
MRC:
The physical configuration of the item.ARJD
Design Form:
Solid
MRC:
Indicates the type of disk.BPLM
Disk Type:
Internal teeth
MRC:
The length of a straight line which passes through the center of the material,and terminates at the inside circumference.BSPH
Material Inside Diameter:
6.500 inches
MRC:
The number of sections on each side of the item.BSPJ
Section Quantity Per Side:
1
MRC:
The number of teeth sets provided.BSPZ
Teeth Set Quantity:
1
MRC:
The number of teeth in each set.BSQB
Teeth Quantity Per Set:
48
MRC:
The number of teeth in each disk.BSQC
Teeth Quantity Per Disk:
48
MRC:
A measurement indicating the diameter-pitch per measurement scale of the teeth.BSQD
Teeth Pitch Diameter:
0.266 inches
MRC:
Those features,not otherwise specified,which may be required for proper functioning of the item.CBBL
Features Provided:
Friction material facing and material facing groove
MRC:
The structural characteristic of the item.CQCF
Construction:
Solid
MRC:
Flexible,capable of being bent,turned or twisted,within limits,without breaking,or rigid,resisting change of form,inflexible.FLEX
Flexibility:
Rigid
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
