رقم الجزء
تجريد
صلاحيه
UOM
NIIN
TXT
وصف:
Compression Helical Spring
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the inside circumference.AARX
Inside Diameter:
Between 0.492 inches and 0.512 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the end.ABQK
End Style:
E4 spring end, squared and ground both ends
Spring Free Length:
Between 1.950 inches and 2.050 inches
MRC:
The number of coils included on the item.APCN
Coil Quantity:
8 1/2
Spring Solid Length:
0.478 inches
MRC:
An indication of the coil helix direction.AXLH
Coil Helix Direction:
Right-hand or left-hand
MRC:
The weight,per specific measurement scale,required to deflect the spring.AXLP
Spring Deflection Rate:
7.680 pounds per inch
Spring Free Outside Diameter:
Between 0.588 inches and 0.612 inches
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Cadmium and chromate
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as type,class,grade,and the like,that identifies the surface treatment material.STDC
Surface Treatment Specification:
Qq-p-416 type 2, class 3 federal specification single treatment response
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Cylindrical
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
19207-12297984-7 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)