رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
6.0 mm diameter hole on shaft is 21.0 mm min and 24.0 mm maximum deep; two holes on head bearing surface are 11.0 mm diameter and 32.0 mm deep and are tapped 0.500 in. 13-2b unc; one hole on head bearing surface is 8.5 mm min diameter and 9.1 mm maximum diameter and 95.0 mm deep and tapped 0.125 in. 27-2b npsf
TXT
وصف:
Headed Grooved Pin
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Chamfered
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the head.AASK
Head Style:
Flat countersunk undercut
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the circumference.ABMZ
Diameter:
Between 76.51 millimeters and 76.63 millimeters
MRC:
A measurement of the longest effective dimension of an item.ABNZ
Effective Length:
44.0 millimeters
Undercut Diameter:
72.57 millimeters
Under Head Length:
151.0 millimeters
Undercut Radius:
Between 12.0 millimeters and 14.0 millimeters
MRC:
The style designation indicating the configuration that most nearly corresponds to the arrangement of the holes.ABRB
Hole Arrangement Style:
One end drilled
First Hole Diameter:
6.0 millimeters
Distance From Centerline Of Hole To End Of Pin:
94.0 millimeters
MRC:
A measurement of the longest dimension of the grip,in distinction from width.ANEE
Grip Length:
57.0 millimeters
MRC:
A numeric value that reflects the hardness of an item when used in conjunction with a hardness rating scale.CQFM
Hardness Rating:
58.0 rockwell c shank
First End Taper Angle:
20.0 degrees
Pin Head Diameter:
Between 89.05 millimeters and 89.55 millimeters
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
0.80 microns shank end
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
1.6 microns head outside diameter
MRC:
A measurement from the bottom to the top of an object,in distinction from depth.HGTH
Height:
Between 32.0 millimeters and 34.0 millimeters
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 1045
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
1e361, fscm 11083 mfr ref single material response
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Groove
