رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Two int thd holes 1.000 in. Lg, 1.500 in. Bolt cir diameter 1st end; 2nd end bored 1.630 in. Dia, 3.500 in. Deep, counterbored 1.741 in. Dia, 2.000 in. Dp, threaded near 2nd end 12 thds per inch
TXT
وصف:
Shouldered Shaft
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Splined (straight)
MRC:
A term used to identify the ends as identical or not identical.AAHN
End Similarity:
Not identical
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the second end.AAHP
Second End Style:
Splined (involute)
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
13.090 inches
MRC:
The length of a straight line which passes through the center of the first end,and terminates at the circumference.AMDL
First End Diameter:
Between 2.4930 inches and 2.4950 inches
MRC:
A measurement of the longest dimension of the first end spline,in distinction from width.AMDM
First End Spline Length:
2.940 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the first end spline,and terminates at the circumference.AMDN
First End Spline Minor Diameter:
Between 2.2680 inches and 2.2730 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the first end spline,and terminates at the circumference.AMDP
First End Spline Major Diameter:
Between 2.4930 inches and 2.4950 inches
MRC:
The length of a straight line which passes through the center of the second end,and terminates at the circumference.AMFZ
Second End Diameter:
Between 3.4070 inches and 3.4120 inches
MRC:
A measurement of the longest dimension of the second end spline,in distinction from width.AMGA
Second End Spline Length:
0.750 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the second end spline,and terminates at the circumference.AMGB
Second End Spline Minor Diameter:
Between 3.0400 inches and 3.0800 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the second end spline,and terminates at the circumference.AMGC
Second End Spline Major Diameter:
Between 3.4070 inches and 3.4120 inches
Second End Pressure Angle:
20.0 degrees
MRC:
A measurement indicating the diameter-pitch per measurement scale of the second end.AMGF
Second End Pitch Diameter:
3.3330 inches
MRC:
The number of steps provided.ATPC
Step Quantity:
8
First End Spline Quantity:
10
Second End Spline Quantity:
20
MRC:
The length of a straight line which passes through the center of the largest step,and terminates at the circumference.CSPY
Largest Step Diameter:
Between 4.062 inches and 4.063 inches
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
63.0 microinches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 4340
