رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Weapon system essential; one half of split flnage kit 4730-01-056-8125, p/n ff593-323
MRC:
The length of a straight line which passes through the center of the recess,and terminates at the circumference.ABMD
Recess Diameter:
2.844 inches
MRC:
A measurement between specified points on the recess,in distinction from height.ABMH
Recess Depth:
0.355 inches
MRC:
A measurement of the smallest dimension of an item,in distinction from length or width.ABNM
Thickness:
0.620 inches
MRC:
The industrial designation or term used to define the nominal diameter of pipe for which the item is designed.ACSU
Pipe Size For Which Designed:
2.000 inches
MRC:
A measurement of the center to center distance between the bolt holes along the length.ADUZ
Center To Center Distance Between Bolt Holes Along Length:
3.062 inches
Outside Edge To Bolt Hole Center Distance Along Width:
1.860 inches
MRC:
The number of bolt holes provided on the item.AECS
Bolt Hole Quantity:
2
MRC:
A measurement of the longest dimension of a flange,in distinction from width.AFQN
Flange Length:
Between 3.938 inches and 4.062 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Wsdc sva-rough terrain container crane, x009
MRC:
The length of a straight line which passes through the center of the bolt hole,and terminates at the circumference.AHNX
Bolt Hole Diameter:
0.531 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the flange section.AJEM
Flange Section Style:
Raised faced, dished
MRC:
The condition of the face seating surface of an item which contacts another surface.AKWE
Face Seating Surface Condition:
Machined
MRC:
The maximum pressure at which an item is rated to operate for each type of service with which an item may be used.CQCJ
Maximum Operating Pressure And Media For Which Designed:
3000.0 pounds per square inch fuel/oil, hydrocarbon
MRC:
The master requirement codes of those requirements which are technically critical by reason of tolerance,fit,performance,or other characteristics which affect identification of the item.CRTL
Criticality Code Justification:
Feat
MRC:
A rating which expresses the degree of heat or cold as applied to the operation,or limitation of operation,for each type of service with which an item may be used.CRWH
Maximum Operating Tempurature And Media For Which Designed:
250.0 degrees fahrenheit fuel/oil, hydrocarbon
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Chromate and zinc
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Bolt hole connector plate
