رقم الجزء
تجريد
صلاحيه
UOM
NIIN
TXT
وصف:
Air Dielectri Variable Capacitor
MRC:
A constant that represents the proportionate change in capacitance caused by a change in temperature,expressed in parts per million per degree celsius.AEBC
Tempurature Coefficient Of Capacitance In Ppm Per Deg Celsius:
50.0 single section
MRC:
The limits of permissible deviation of the temperature coefficient from the rated value,expressed in parts per million per degree celsius.AEBD
Tolerance Of Tempurature Coefficient In Ppm Per Deg Celsius:
-50.0/+50.0 single section
MRC:
Direct current resistance between two conductors that are separated by an insulating material,measured at the maximum operating temperature of the item.AXGX
Insulation Dc Resistance At Max Operating Temp:
10.0 gigohms
MRC:
The temperature/s/ at which an item can function without voltage derating.CQJJ
Nonderated Operating Temp:
Between -65.0 degrees celsius and 125.0 degrees celsius
MRC:
The minimum and maximum values of the electrical capacitance measured between two specified points on the item,expressed in picofarads.CTGN
Capacitance Range In Picofarads:
+0.6/+3.5 single section
MRC:
The highest potential and type that may be applied to the item,at the highest operating temperature permissible without voltage derating.CTGP
Nonderated Voltage Rating And Type:
500.0 dc continuous single section
MRC:
Indicates the type and number of drive(s) provided for the adjustment device.CTGR
Adjustment Device Drive Type And Quantity:
1 slotted screw
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
45413-sk139780 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
