رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Filler foam
TXT
وصف:
Cellular Plastic Material
MRC:
An indication of whether or not an object will remain substantially unchanged when subjected to extremely high temperatures.AAAU
Fire Retarding Characteristic:
Not fire retarding
MRC:
A measurement taken at right angles to the length of an item,in distinction from thickness.ABGL
Width:
16.760 inches
MRC:
A measurement of the smallest dimension of an item,in distinction from length or width.ABNM
Thickness:
6.790 inches
MRC:
A measurement of the longest dimension of any object,in distinction from width.ABRY
Length:
24.620 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Aircraft, thunderbolt ii, a-10
MRC:
The condition of the item with respect to the texture of the surface.APEA
Surface Condition:
Rough
MRC:
An indication of the rated density of the item.BDNZ
Density Rating:
1.2 pounds per cubic foot
MRC:
The squeezing load an item can withstand without breaking at 25 percent deflection.CTLY
Compression Strength At 25 Pct Deflection:
0.35 pounds per square inch
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Irregularly shaped - see drawing for details; far side has 30 degree cutout along left/long edge (far side up) & roughly triangular cutout along right edge, 30 to 15 degrees top to bottom (far side up) and is marked along left edge: "fwd" near boot corner, "up" in center & part number near top; near side slants crosswise from bottom 30 degree cut to 0.50 from top, 9.71 from left edge, on to meet top, 4.85 from left & back to 0.50 from top at left edge; upper surface has graduated lengthwise angles; bottom edge has crosswise cut of 30 degrees, bottom surface to top surface; there is a v-shaped cutout, with 1 side starting 9.37 inches from bottom edge & 2.00 inches deep, at 30 degree angle toward top surface & toward bottom edge & opposite cut from 11.75 from bottom edge, 2.00 deep, 30 degrees toward top surface & toward top edge
MRC:
The element,compound,or mixture of which an item is fabricated,excluding any surface treatment.MATL
Material:
Plastic, polyurethane
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Plastic polyurethane
MRC:
Characteristics or qualities of an item,not covered in any other requirement,which are considered essential information for one or more functions excluding nsn assignment.SUPP
Supplementary Features:
Material to be reticulated foam per sm-alc specification ms-mmrs-87-100
