رقم الجزء
تجريد
صلاحيه
UOM
NIIN
MRC:
The ability of an item to withstand a specified torque load without fracture.AAPL
Torque Load Rating:
16.0 inch-pounds
MRC:
The length of a straight line which passes through the center of the smallest cross section of a spline,and terminates at the circumference.AAUH
Spline Minor Diameter:
Between 0.645 inches and 0.654 inches
MRC:
The length of a straight line which passes through the center of the largest cross section of a spline,and terminates at the circumference.AAUJ
Spline Major Diameter:
Between 0.738 inches and 0.741 inches
MRC:
Indicates the type of mount utilized to support the item.AAXX
Mounting Type:
Flange
MRC:
The number of splines on or in the item.ABSA
Spline Quantity:
17
MRC:
The length of a straight line which passes through the center of a mounting hole,and terminates at the circumference.ABTB
Mounting Hole Diameter:
Between 0.342 inches and 0.352 inches
MRC:
The number of mounting holes provided.ABTJ
Mounting Hole Quantity:
4
MRC:
The speed of the drive shaft required to produce the rated capacity of an item,expressed in revolutions per minute.AEQC
Operating Speed At Rated Capacity In Rpm:
100.0
MRC:
The length of a straight line which passes through the center of a mounting bolt circle,and terminates at the circumference.AFFL
Mounting Bolt Circle Diameter:
5.500 inches
MRC:
A measurement indicating the diameter-pitch per specific measurement scale of the item.AGJS
Pitch Diameter:
0.708 inches
MRC:
Indicates the type of drive shaft by the physical configuration,condition,and the like of the shaft end.AJAB
Drive Shaft Type:
Splined, involute external
MRC:
The direction of rotation of a rotating shaft as viewed from the drive end.AKCT
Shaft Rotation Direction:
Clockwise and counterclockwise
MRC:
A measurement of the spline pitch of the item.ASAP
Spline Pitch:
24/48
MRC:
The number of connections furnished.ASMM
Connection Quantity:
1 and 2
MRC:
Indicates the type of connection/s/.AWLS
Connection Type:
Inlet and drain
MRC:
The pressure angle of the spline,expressed in degrees.AXFG
Spline Pressure Angle In Deg:
30.0
MRC:
A measurement of the longest dimension of a spline,in distinction from width.AXFH
Spline Length:
0.875 inches
MRC:
Indicates the displacement type.AXFP
Displacement Type:
Constant
MRC:
An indication of the constant displacement per revolution.AXFQ
Constant Displacement Per Revolution:
1.000 cubic inches
