رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Gear, impeller
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the body.AAQL
Body Style:
Spoked
MRC:
The number of splines on or in the item.ABSA
Spline Quantity:
41 both ends
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
3930-01-384-5310
MRC:
A measurement indicating the diameter-pitch per specific measurement scale of the item.AGJS
Pitch Diameter:
88.9 millimeters
MRC:
The number of teeth included on the item.AJLA
Teeth Quantity:
35
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the bore.ANTP
Bore Style:
Involute spline both ends
MRC:
A measurement of the spline pitch diameter.BDTX
Spline Pitch Diameter:
52.07 millimeters both ends
MRC:
A numeric value that reflects the hardness of an item when used in conjunction with a hardness rating scale.CQFM
Hardness Rating:
58.0 rockwell c body and 63.0 rockwell c body
MRC:
The nominal length of a straight line which passes through the center of an item,and terminates at the outside circumference.CWCD
Outside Diameter:
92.4 millimeters
MRC:
The measurement of the pressure angle on the item.CWPP
Pressure Angle:
20.0000 degrees
MRC:
The nominal distance between the body face and the protruding hub end.CWQL
Distance Between Body Face And Protruding Hub End:
1.5 millimeters both ends
MRC:
A measurement taken at right angles to the length of the face,in distinction from thickness.CWRM
Face Width:
16.05 millimeters
MRC:
The nominal length of a straight line which passes through the center of a bore,and terminates at the circumference.CWRS
Bore Diameter:
54.64 millimeters both ends
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the hub.CWTR
Hub Style Designator:
Plain both ends
MRC:
The nominal length of a straight line which passes through the center of a hub,and terminates at the circumference.CWTX
Hub Diameter:
69.85 millimeters both ends
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Spline and teeth file hard. No.60 file per sae specification j864
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Protruding hubs
