رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Both ends 63.0 microinches finish
TXT
وصف:
Headless Straight Pin
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Chamfered
MRC:
The overall dimension measured along the longitudinal axis,with terminated points at the extreme ends of the pin.ACHT
Pinlength:
Between 0.248 inches and 0.252 inches
MRC:
The overall length of a straight line which passes through the center of the pin,and terminates at the outside circumference.ACHU
Pindiameter:
Between 0.0933 inches and 0.0935 inches
First End Taper Length:
Between 0.010 inches and 0.015 inches
MRC:
Those features,not otherwise specified,which may be required for proper functioning of the item.CBBL
Features Provided:
Casehardened
MRC:
Indicates whether or not the second end is identical to the first end.CQBB
Second End Relationship With First End:
Identical
First End Taper Angle:
45.0 degrees
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
32.0 microinches outside diameter
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 440c
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Ams 5630 assn standard single material response
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
99207-50t1068 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
