رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Shaft-drive arm crew entry door
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Splined (straight)
MRC:
A term used to identify the ends as identical or not identical.AAHN
End Similarity:
Identical
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
Between 9.120 inches and 9.140 inches
MRC:
The length of a straight line which passes through the center of the first end,and terminates at the circumference.AMDL
First End Diameter:
Between 1.4970 inches and 1.5000 inches
MRC:
A measurement of the longest dimension of the first end spline,in distinction from width.AMDM
First End Spline Length:
Between 1.400 inches and 1.420 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the first end spline,and terminates at the circumference.AMDN
First End Spline Minor Diameter:
Between 1.3982 inches and 1.4063 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the first end spline,and terminates at the circumference.AMDP
First End Spline Major Diameter:
Between 1.4970 inches and 1.5000 inches
MRC:
The length of a straight line which passes through the center of the second end,and terminates at the circumference.AMFZ
Second End Diameter:
Between 1.4970 inches and 1.5000 inches
MRC:
A measurement of the longest dimension of the second end spline,in distinction from width.AMGA
Second End Spline Length:
Between 2.400 inches and 2.420 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the second end spline,and terminates at the circumference.AMGB
Second End Spline Minor Diameter:
Between 1.3982 inches and 1.4063 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the second end spline,and terminates at the circumference.AMGC
Second End Spline Major Diameter:
Between 1.4970 inches and 1.5000 inches
First End Spline Quantity:
47
Second End Spline Quantity:
47
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
125.0 microinches
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
2 holes one in each end through spliines, diameter of both holes is 0.218 to 0.224, center to center between holes is 6.930 to 6.940, hole located 1.700 from 2nd end and 1.410 from 1st end
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Ams 5659 assn standard single material response
