رقم الجزء
تجريد
صلاحيه
UOM
NIIN
رقم الجزء:
5100-4700-470171alt2pc72
معلومات الجزء
Large end counterbored 1.693 in. Diameter 0.250 in. Deep
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the outside circumference.ABKV
Outside Diameter:
2.000 inches
MRC:
A measurement of the smallest dimension of an item,in distinction from length or width.ABNM
Thickness:
0.500 inches
MRC:
The length of a straight line which passes through the center of the small end,and terminates at the circumference.ABPH
Small End Diameter:
1.625 inches
MRC:
The length of a straight line which passes through the center of a circular bore,and terminates at the circumference.ABXV
Bore Diameter:
Between 0.1181 inches and 0.1182 inches
Largest Diameter Length:
0.250 inches
MRC:
Designates the specific roughness rating representing the arithmetic average deviation of the surface from the meanline in profile,and its location on the item.CSFN
Surface Finish And Location:
125 microinches outside periphery
MRC:
Designates the specific roughness rating representing the arithmetic average deviation of the surface from the meanline in profile,and its location on the item.CSFN
Surface Finish And Location:
125 microinches both bearing flats
MRC:
Designates the specific roughness rating representing the arithmetic average deviation of the surface from the meanline in profile,and its location on the item.CSFN
Surface Finish And Location:
125 microinches inside periphery
MRC:
The element,compound,or mixture of which an item is fabricated,excluding any surface treatment.MATL
Material:
Copper alloy, qq-c-390, alloy d5
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Copper alloy 903
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Qq-c-390, alloy d5 federal specification single material response
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Round stepped
