رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
One 0.029 in. Min, 0.032 in. Maximum wby 0.288 in. Min, 0.292 in. Maximum diameter groove located 1.130 in. Min, 1.132 in.Max from first end
TXT
وصف:
Shouldered Shaft
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Unthreaded cross drilled
MRC:
A term used to identify the ends as identical or not identical.AAHN
End Similarity:
Not identical
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the second end.AAHP
Second End Style:
Circular grooved and splined (straight)
Second End Groove Width:
Between 0.0290 inches and 0.0320 inches
Second End Groove Diameter:
Between 0.2880 inches and 0.2920 inches
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
4.440 inches
MRC:
The length of a straight line which passes through the center of the first end,and terminates at the circumference.AMDL
First End Diameter:
Between 0.3147 inches and 0.3150 inches
MRC:
The length of a straight line which passes through the center of a hole or body of the first end,and terminates at the circumference.AMDX
First End Hole Diameter:
Between 0.0940 inches and 0.0970 inches
First End Distance From Hole Center To End:
Between 0.312 inches and 0.343 inches
Second End Distance From End To Groove:
0.560 inches
MRC:
The length of a straight line which passes through the center of the second end,and terminates at the circumference.AMFZ
Second End Diameter:
Between 0.2790 inches and 0.2810 inches
MRC:
A measurement of the longest dimension of the second end spline,in distinction from width.AMGA
Second End Spline Length:
0.500 inches
MRC:
The length of a straight line which passes through the center of the smallest circular cross section of the second end spline,and terminates at the circumference.AMGB
Second End Spline Minor Diameter:
0.2349 inches
MRC:
The length of a straight line which passes through the center of the largest circular cross section of the second end spline,and terminates at the circumference.AMGC
Second End Spline Major Diameter:
0.2500 inches
MRC:
The number of steps provided.ATPC
Step Quantity:
5
Second End Spline Quantity:
16
MRC:
The length of a straight line which passes through the center of the largest step,and terminates at the circumference.CSPY
Largest Step Diameter:
Between 0.390 inches and 0.400 inches
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
16.0 microinches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Stainless steel
