رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Bulkhead fitting
TXT
وصف:
Pipe To Boss Straight Adapter
MRC:
A measurement of the pipe size the item will accommodate.AAAR
Pipe Size Accommodated:
0.250 inches all ends
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Mine detection towing vehicle (mdtv) 4x4 husky
MRC:
A nominal measurement of the longest dimension of an item,in distinction from width.AKGG
Length:
1.000 inches all ends
MRC:
Indicates the type of connection/s/.AWLS
Connection Type:
Threaded internal tube all ends
MRC:
The number of threads on the item per linear inch measured on a line parallel to the thread axis.CMLP
Thready Qty Per Inch (tpi):
A18 all ends
MRC:
The maximum pressure at which the item is rated for operation.CQGM
Maximum Operating Pressure:
1000.0 pounds per square inch single response
MRC:
A designation that is used for the purpose of general identification of the thread.CQJX
Thread Size:
0.250 inches all ends
MRC:
The nominal length of a straight line which passes through the center of an item,and terminates at the outside circumference.CWCD
Outside Diameter:
0.750 inches center bulkhead
MRC:
The shortest nominal straight line between flats,perpendicular to the height of an item.CWCN
Width Across Flats:
0.875 inches 1st end
MRC:
The nominal dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.CWFR
Nominallength:
1.000 inches
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Yellow brass bulkhead fitting, 3/4-20 inch outside thread with lock washers and lock nut, 1/4 inch 18 inch npt internal threads at both ends, panel hole size: 25/32 inch
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Copper alloy
MRC:
A designation distinguishing one group of thread diameter-pitch combinations from another by the number of threads per measurement scale for a specific diameter.THSD
Thread Series Designator:
Npt all ends
