رقم الجزء
تجريد
صلاحيه
UOM
NIIN
TXT
وصف:
Photo Semiconductor Device
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
1.114 inches
MRC:
The distance measured in a straight line from the bottom to the top of an item.ABKW
Overall Height:
1.0475 inches
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
0.095 inches
MRC:
The time required for an item to respond to a specific condition.ASCK
Response Time:
8.0 microseconds
MRC:
The value of the voltage that may be applied,expressed in volts,and the symbol used to identify the specific electrical characteristic.CTQN
Voltage Rating In Volts Per Characteristic:
50.0 breakdown voltage, collector-to-emitter, base open and 7.0 breakdown voltage, emitter to collector, base open and 0.3 collector to emitter saturation voltage
MRC:
The level of electrical flow and the symbol used to identify the specific electrical characteristic.CTQX
Current Rating Per Characteristic:
3.00 milliamperes collector cutoff current, dc, emitter open and 25.00 nanoamperes repetitive peak forward current peak
MRC:
The maximum temperature at which the item is designed to operate at each measurement point.CTSG
Maximum Operating Tempurature Per Measurement Point:
125.0 degrees celsius ambient air
MRC:
An indication of the precious material and its location in the item.PMLC
Precious Material And Location:
Finish gold
MRC:
Identification of the precious material contained in the item.PRMT
Precious Material:
Gold
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
11263-65008g drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
