رقم الجزء
تجريد
صلاحيه
UOM
NIIN
رقم الجزء:
68a410784-2005
معلومات الجزء
Hole in head of pin 0.1560 in. Min diameter 0.1641 in. Maximum dia, 0.200 in. Deep; countersunk 90.0 degree by 0.217 in. Dia; threaded 10-32 unf-2a, 0.200 in. Deep
TXT
وصف:
Headed Grooved Pin
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the first end.AAGZ
First End Style:
Square
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the head.AASK
Head Style:
Fillister
MRC:
The length of a straight line which passes through the center of a circular figure or body,and terminates at the circumference.ABMZ
Diameter:
Between 0.5015 inches and 0.5025 inches
Undercut Diameter:
Between 0.430 inches and 0.440 inches
Under Head Length:
Between 0.437 inches and 0.442 inches
Undercut Radius:
0.030 inches
Pin Head Diameter:
Between 0.620 inches and 0.630 inches
MRC:
The master requirement codes of those requirements which are technically critical by reason of tolerance,fit,performance,or other characteristics which affect identification of the item.CRTL
Criticality Code Justification:
Supp
MRC:
A measurement from the bottom to the top of an object,in distinction from depth.HGTH
Height:
Between 0.090 inches and 0.095 inches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Copper alloy 172
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Qq-c-530 cond h federal specification single material response
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Groove
MRC:
Characteristics or qualities of an item,not covered in any other requirement,which are considered essential information for one or more functions excluding nsn assignment.SUPP
Supplementary Features:
Item is not csi but has critical features such as tolerance, heat treatment, surface finish, or material type and special insp. Req.S such as magnetic particle insp. Or fluorescent penetrant inspection
