رقم الجزء
تجريد
صلاحيه
UOM
NIIN
رقم الجزء:
74a480612-2003
معلومات الجزء
Two tabs on od surface of body, 180 degrees apart
MRC:
The distance,measured along a straight line perpendicular to the longitudinal axis of the slot,from one edge to the other.ABGC
Slot Width:
1.3750 inches first
MRC:
A measurement of the longest dimension of the slot,in distinction from width.ABGD
Slot Length:
0.7100 inches first
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
8.0200 inches
MRC:
The length of a straight line which passes through the center of the body,and terminates at the outside circumference.ADAR
Body Outside Diameter:
Between 2.9570 inches and 2.9580 inches
MRC:
The length of a straight line which passes through the center of a body,and terminates at the inside circumference.ADAS
Body Inside Diameter:
Between 2.7540 inches and 2.7560 inches
Right Internal Flange Hole Diameter:
2.5150 inches
Right Internal Flange Width:
Between 0.4950 inches and 0.5050 inches
MRC:
Designates the specific surface roughness rating,representing the arithmetic average deviation of the surface from the meanline in profile.CSYM
Surface Finish:
125.0 microinches
MRC:
Indicates the type and number of features used for the introduction of a lubricant or an antirotational device.CTJM
Antirotation/lubrication Type And Quantity:
2 slot
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
17c-1 solid, plain, no outside flanges, internal flange one end
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
76301-ps21202 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
