رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Impedance 50 ohms
TXT
وصف:
Directional Coupler
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
Between 0.830 inches and 0.870 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
F15s
MRC:
The number of complete cycle changes of radiated electromagnetic energy,per unit of time,for which an item is rated.ANKZ
Radio Frequency Rating:
Between 10.0 megahertz and 18.0 gigahertz
MRC:
Indicates the design type of the item.APGF
Design Type:
Bidirectional
MRC:
Indicates the type of unit.APQB
Unit Type:
Coaxial line
MRC:
The maximum to minimum voltage standing wave ratio at a specified frequency/ies/.BGPS
Voltage Standing Wave Ratio At Reference Frequency:
1.35 to 1
MRC:
The amount of decrease in power,expressed in decibels.BGPX
Power Loss In Decibels:
0.5
MRC:
The nomenclature by which the terminal fitting is identified.BGPY
Terminal Fitting Name:
Sma female; sma male
MRC:
The name of the government agency or commercial organization that controls the terminal fitting.BGPZ
Terminal Fitting Controlling Agency:
Inmet corporation
MRC:
An identifying number assigned by the government agency or commercial organization controlling the terminal fitting.BGQB
Terminal Fitting Identifying Number:
Part no. 8055
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
64671-407-0190 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
