رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Additional slot beginning 0.085 from slotted end dimensions of 0.040 wide, 0.465 / 0.470 maximum deep from outside edge circumferencing item
MRC:
The minimum and maximum pitch diameter limits of a straight screw thread.AAJE
Thread Pitch Diameters:
+0.3257/+0.3303 inches
MRC:
The direction of the thread when viewed axially. a right-hand thread winds in a clockwise direction while a left-hand thread winds in a counterclockwise direction.AAJF
Thread Direction:
Right-hand
Drive Point Depth:
Between 0.050 inches and 0.060 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the nut.ACTA
Nut Style:
Round
Nut Diameter:
0.500 inches
MRC:
A measurement between the opposite flat surfaces of the nut,in distinction from length or width.ADBG
Nut Thickness:
0.438 inches
Drive Point Width:
0.064 mils and 0.069 centimeters
MRC:
Indicates the type and number of holes provided.ALET
Hole Type And Quantity:
2 tapped
MRC:
A designation indicating the diameter-pitch combination and the number of threads per measurement scale applied to a series of diameters.BZRR
Thread Series:
Uns
MRC:
The number of threads on the item per linear inch measured on a line parallel to the thread axis.CMLP
Thready Qty Per Inch (tpi):
36
MRC:
A designation that is used for the purpose of general identification of the thread.CQJX
Thread Size:
0.344 inches
MRC:
The number of hole threads per linear inch measured on a line parallel to the thread axis.CQTW
Hole Thready Qty Per Inch (tpi):
56
MRC:
The style designation that most nearly corresponds to the appearance of the hole configuration.CRHC
Hole Configuration Style:
Configuration j
MRC:
The included angle of the countersink.CRSQ
Countersink Angle:
45.0 degrees nut
MRC:
The nominal length of a straight line which passes through the center of the threaded hole,and terminates at the circumference.CSPF
Hole Thread Diameter:
0.086 inches
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Copper alloy 360
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Qq-b-626 federal specification single material response