رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Rivet, solid, universal head, alluminum alloy and titanium columbium alloy
MRC:
The dimension,measured along a line parallel to the longitudinal axis,from the largest bearing surface of the fastener head to the extreme opposite end,or as specifically designated for other type fasteners.AASB
Fastener Length:
Between 0.428 inches and 0.448 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the head.AASK
Head Style:
Oval/truss
MRC:
A measurement from the bottom to the top of the head,in distinction from depth.AASU
Head Height:
Between 0.093 inches and 0.103 inches
MRC:
The length of a straight line which passes through the center of the body of the shank and terminates at the circumference.AAZE
Shank Diameter:
Between 0.218 inches and 0.222 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the shank.AAZF
Shank Style:
Straight w/radius chamfered tip
Head Major Diameter:
Between 0.415 inches and 0.459 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
Fathometer, an, bqn-17
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
End item c-17 aircraft; rivets may be furnished with plain ends, or ends chamfered up to 20 degrees to the "s" dimention, or may have a radius to the "t" dimention; chemical surface treatment per mil-c-5541, class 1a gold/yellow; outer diameter of indented ring shall be a of 75 percent of rivet shank diameter; the depth of the ring shall be .010 inch; indented ring is required on 7050 rivets manufactured after 2 july 1990
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Aluminum alloy 7050
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Qq-a-430 federal specification single material response
