رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Furnished w/o bolt
MRC:
The dimension,measured along a line parallel to the longitudinal axis,from the largest bearing surface of the fastener head to the extreme opposite end,or as specifically designated for other type fasteners.AASB
Fastener Length:
Between 1.190 inches and 1.210 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the head.AASK
Head Style:
Flush (flat) countersunk (included angle - less than 135 degrees w or w/o chamfer)
MRC:
The length of a straight line which passes through the center of the body of the shank and terminates at the circumference.AAZE
Shank Diameter:
Between 0.387 inches and 0.390 inches
Head Major Diameter:
Between 0.445 inches and 0.450 inches
MRC:
The device by which the item is expanded and set.ABAF
Expansion Device:
Threaded sleeve
MRC:
A measurement of the longest dimension of the grip,in distinction from width.ANEE
Grip Length:
0.750 inches
MRC:
The minimum load,applied perpendicularly to the longitudinal axis of an item,at which point the item will fracture when subjected to the standard shear test method.CQSX
Shear Strength:
125000 single pounds per square inch
MRC:
The included angle of the countersink.CRSQ
Countersink Angle:
100.0 degrees
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 431 expander
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel comp 305 sleeve
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Mil-s-18732 military specification single material response expander
MRC:
The specification,standard,or manufacturers reference,and the classification designation,such as class,condition,temper,and the like,that identifies the material.MDCL
Material Specification:
Qq-s-763 federal specification single material response sleeve
