رقم الجزء
تجريد
صلاحيه
UOM
NIIN
TXT
وصف:
Sleeve Bearing Half
MRC:
The length of a straight line which passes through the center of a hole,and terminates at the circumference.AAUB
Hole Diameter:
0.1250 inches first
MRC:
The length of a straight line which passes through the center of the body,and terminates at the outside circumference.ADAR
Body Outside Diameter:
2.0430 inches
MRC:
The length of a straight line which passes through the center of a body,and terminates at the inside circumference.ADAS
Body Inside Diameter:
Between 1.9190 inches and 1.9194 inches
MRC:
The element,compound,or mixture with which the item is lubricated.ADZG
Lubrication Material:
Lubricating oil
MRC:
A measurement from the outer surface of an item to the outermost point of the locking lug.AGKT
Locking Lug Height:
Between 0.0310 inches and 0.0410 inches
MRC:
The distance,measured along a straight line parallel to the longitudinal axis of the lug,from one edge to the other.AGKU
Locking Lug Length:
Between 0.1875 inches and 0.2188 inches
MRC:
The distance,measured along a straight line,perpendicular to the longitudinal axis of the lug,from one edge to the other.AGKV
Locking Lug Width:
Between 0.1500 inches and 0.1550 inches
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square all corners
MRC:
Indicates the type and number of features used for the introduction of a lubricant or an antirotational device.CTJM
Antirotation/lubrication Type And Quantity:
2 hole
MRC:
The angle formed by the centerline of the bearing and the centerline of two holes not in the same plane.CTLF
Hole Spacing Angle:
60.0 degrees
Distance From Lug End To End Of Bearing:
Between 0.1290 inches and 0.1340 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
17d half sleeve, plain, no outside flanges
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Half sleeve, plain, no outside flanges
