رقم الجزء
تجريد
صلاحيه
UOM
NIIN
TXT
وصف:
Engine Accessory Generator
MRC:
The length of a straight line which passes through the center of the smallest cross section of a spline,and terminates at the circumference.AAUH
Spline Minor Diameter:
0.809 inches
MRC:
The length of a straight line which passes through the center of the largest cross section of a spline,and terminates at the circumference.AAUJ
Spline Major Diameter:
Between 0.862 inches and 0.867 inches
Spline Width:
0.073 inches
MRC:
The number of splines on or in the item.ABSA
Spline Quantity:
16
MRC:
The length of a straight line which passes through the center of a mounting hole,and terminates at the circumference.ABTB
Mounting Hole Diameter:
0.500 inches
MRC:
The number of mounting holes provided.ABTJ
Mounting Hole Quantity:
12
Mounting Hole Circle Radius:
1.520 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the mounting.ADER
Mounting Style:
Round flange with holes equally spaced
MRC:
The environmental elements or conditions that an item is designed or protected to resist or withstand satisfactorily.ADZC
Environmental Protection:
Dustproof
MRC:
An indication of whether or not an item is capable of operation while submerged.AHZV
Submersibility:
Nonsubmersible
MRC:
The direction of rotation of a rotating shaft as viewed from the drive end.AKCT
Shaft Rotation Direction:
Clockwise
MRC:
A measurement of the longest dimension of a spline,in distinction from width.AXFH
Spline Length:
0.750 inches
MRC:
Indicates the type of ground polarity utilized.AXHX
Ground Polarity Type:
Negative
MRC:
The minimum speed the armature can revolve and maintain full current output,expressed in revolutions per minute.BCGD
Armature Minimum Speed In Rpm At Full Current Output:
1900
MRC:
The maximum amount of output current for which the item is rated,expressed in amperes.BCGF
Maximum Output Current Rating In Amps:
500.0
MRC:
The cut-in speed necessary to maintain a minimum current flow,expressed in revolutions per minute.BCGG
Minimum Current Cut-in Speed In Rpm:
1500
MRC:
Indicates the location of the rectifier for the item.BCGM
Rectifier Location:
Integral
MRC:
The means by which the item is grounded.BCGN
Grounding Method:
Internal
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the shaft drive end.BCGS
Shaft Drive End Style:
Splined shaft end
MRC:
The speed the armature can revolve and produce maximum current,expressed in revolutions per minute.BCND
Maximum Rated Armature Speed In Rpm:
8000
MRC:
The total electrical voltage.ELEC
Voltage In Volts:
28.5
