رقم الجزء
تجريد
صلاحيه
UOM
NIIN
معلومات الجزء
Right end surface of flange, right end surface of body square w/od within 0.002 in. Tir, 4 scallops equally spaced on right end surface ofbody, 4 holes through flange equally spaced on 2.376 in. Bolt circle dia, left side of flange reduced to 1.780 in. Diameter by 0.110 in. Lg
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
Between 1.3580 inches and 1.3800 inches
MRC:
The length of a straight line which passes through the center of the body,and terminates at the outside circumference.ADAR
Body Outside Diameter:
Between 1.4990 inches and 1.4995 inches
MRC:
The length of a straight line which passes through the center of a body,and terminates at the inside circumference.ADAS
Body Inside Diameter:
Between 0.9388 inches and 0.9395 inches
MRC:
The length of a straight line which passes through the center of the flange,and terminates at the outside circumference.AEPR
Flange Outside Diameter:
Between 2.8000 inches and 2.8200 inches
MRC:
A measurement taken at right angles to the length of a flange,in distinction from thickness.AGFF
Flange Width:
Between 0.2100 inches and 0.2300 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the means whereby the lubricant is set into the item.AGKH
Lubricant Accommodation Style:
Grooved circular
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Relief groove left flange body corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square inside right corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square inside left corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square left flange outside right corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square outside left corner
MRC:
The physical configuration of the corner.BZLX
Corner Shape:
Square outside right corner
MRC:
Indicates the type and number of features used for the introduction of a lubricant or an antirotational device.CTJM
Antirotation/lubrication Type And Quantity:
7 hole
