رقم الجزء
تجريد
صلاحيه
UOM
NIIN
TXT
وصف:
Sleeve Bearing Half
MRC:
The length of a straight line which passes through the center of a hole,and terminates at the circumference.AAUB
Hole Diameter:
0.2400 inches and 0.2600 inches first
MRC:
The length of a straight line which passes through the center of the body,and terminates at the outside circumference.ADAR
Body Outside Diameter:
2.4375 inches
MRC:
The length of a straight line which passes through the center of a body,and terminates at the inside circumference.ADAS
Body Inside Diameter:
Between 2.2469 inches and 2.2479 inches
Left Flange Outside Diameter:
Between 3.0950 inches and 3.1550 inches
Right Flange Outside Diameter:
Between 3.0950 inches and 3.1550 inches
Left Flange Width:
Between 0.1010 inches and 0.1030 inches
Right Flange Width:
Between 0.1010 inches and 0.1030 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the means whereby the lubricant is set into the item.AGKH
Lubricant Accommodation Style:
Grooved circular
MRC:
A measurement from the outer surface of an item to the outermost point of the locking lug.AGKT
Locking Lug Height:
Between 0.0450 inches and 0.0550 inches
MRC:
The distance,measured along a straight line parallel to the longitudinal axis of the lug,from one edge to the other.AGKU
Locking Lug Length:
Between 0.1900 inches and 0.2200 inches
MRC:
The distance,measured along a straight line,perpendicular to the longitudinal axis of the lug,from one edge to the other.AGKV
Locking Lug Width:
Between 0.1750 inches and 0.1800 inches
MRC:
Indicates the type and number of features used for the introduction of a lubricant or an antirotational device.CTJM
Antirotation/lubrication Type And Quantity:
2 hole
MRC:
The angle formed by the centerline of the bearing and the centerline of two holes not in the same plane.CTLF
Hole Spacing Angle:
78.0 degrees
MRC:
Indicates the location and number of grooves on the surface of the item.CTMQ
Surface Groove Location And Quantity:
1 internal
Distance From Lug End To End Of Bearing:
Between 0.4435 inches and 0.4530 inches
MRC:
The metallic,nonmetallic,and/or chemical properties with which the item is plated,dipped,and/or coated.the treatment is designed to protect the surface(s) and cannot be wiped off.SFTT
Surface Treatment:
Tin
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
18d half sleeve, external flanges both ends
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the item.STYL
Style Designator:
Half sleeve, external flanges both ends
