معلومات الجزء
Gage set; consists of 3 go/no go gages; gage 1 marked; use this gage at jeim or depot to inspect min-max gap between nose piece t.E. And outer shroud within 2.0 in. Either side of igniter ports, to determine if rework is rqrd, gage 2: .095-.180 check max-min between nosepiece t.E. And outer shroud within 2.0 in. Either side of igniter ports after reword is performed, gage 3: .075.200, check gagp between nose piece and inner or outer shroud except within 2.0 in. Either side of igniter ports to determine if rework is required or to check after rework is performed; matl steel, dim.: .25 x .75 x 8.75, weight: 3 lbs approx
